Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have a CAT6509 whith a FWM (firewall module). I have two ways to access the FWM - by ssh or telnet into the CAT6509 and then I do the command session (fwm slot).My question is:is it possible to disable the session (fwm slot). That is I only want...
Hi,I´m configuring the MSFC2 of a CAT6509 but when a try to config a standby groups the MSFC2 gives the following message "More than 16 standby groups not supported in this platform". But I have another CAT6509 in another buillding with more than 16...
Hi,I have a CaAT 2950 and I want to configure port security on Fast Eth ports.I´ve done the following config:interface FastEthernet0/1 switchport mode access switchport port-security no ip address spanning-tree portfastIn the documentation in Cisco t...
Hi,I have 2 cisco PIXs with the last sw 6.2. The are in failover and they have have also stateful failover (with RJ45 cable). When the primary PIX goes down and the secondary goes up(than it becomes the primary) all connections stay alive unless the ...
Hello,Why don´t you reserve the router IP address in the DHCP server, i.e, that IP address can not be distribute to any machine, it is reserved only for the router.Regards
Your IP address and your default-gateway must be on the same network.Example:PC IP address - 192.168.1.1PC SubNetMAsk - 255.255.255.0 (Class C)PC Defaul-Gateway - 192.168.1.254You can not have (for example) the PC default-gateway - 192.168.1.254 (th...
