Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I have a SIP endpoint connected to a CISCO 2811 (IOS 15.0). The dial peer looks:dial-peer voice 1 voipdescription conection with SIP_endpointdestination-number .Tsession protocol sipv2session target ipv4:192.168.1.60codec g711ulawA test call fr...
Hello,When Xlite is in the same network with CME the registration works fine. When I try to connect Xlite outside the network I receive 408 - Request Timeout. The CME is behind NAT so I configure port forward - public 5060 to CME 5060 port, but the s...
Hello,Is it possible to transcode 3 simultaneous calls from G729r8 to G711 without any DSP modules. I have Cisco 2811 , IOS 12.4(13r)T11, 2 x VWIC2-1MFT-T1/E1 cards. In other words how many calls can I transcode between this 2 codecs with Cisco 2811 ...
Hello,I'm kind of new in this domain so I'd like to have an advise from someone more advanced. What cisco solution is the best for terminating voice calls with a high precent of G729r8, g729br8, g729r8-prietf codecs to an ISDN trunk?Thank you.
Thank for your answer Paolo.But for a small application SIP->ISDN(~30 simultaneous calls) is suitbale a Cisco 2610 Series configured with a WIC-1B-S/T?
