hi,I have configured a Cisco 350 series bridge, as rugged access point, with 3 vlans (native, voice, data), and its respective SSID (admin, phone, guest). Every thing it's ok, conversations between 7920 and 7912, with 7960, 7920, etc... but when I in...

Hi folks,I have to add the SRST configuration to a running MGCP gateway (2621XM ver12.2(15)T11) with two Callmanager 3.3(3). Do I have to add this? Is something missed? (I also post the running-config)dial-peer voice 10 potsapplication mgcpappincomin...

What does it mean the "Unexpected indication (4) in f3 code" when I clear the bri interface?Router-1#clear interface bri 0/1May 16 08:40:31.128 UTC2: BRI0/1 : Unexpected indication (4) in f3 codeMay 16 08:40:31.132 UTC2: %ISDN-6-LAYER2DOWN: Layer 2 f...

hi,I have added a 1760 gateway (Version 12.3(2)XC2) to my Call Manager 3.3(3)sr4a , and everything works, except for the voice in inbound calls. When I unhook the ip-phone, there is no voice.This is the configuration and I attached the debug.R_JAR00...

hi,I have configured SRST with the correct IP phones, platforms, and Cisco CallManager version, etc... and everything works fine in SRST mode, except when I receive a call from the POTS. The destination ip-phone Rings but then no voice sounds.Where c...