Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everyone,I hope everyone is doing well.I was looking at some q-in-q concepts and if anyone can tell me what i am doing wrong i would be forever grateful.Topology:SW1:interface GigabitEthernet1/0/8
switchport access vlan 1024
switchport mode acc...
Hello everyone, Once again i am a bit confused and ask for your help. With regards to control plane policing, i was wondering if is it a way to block, as an example, telnet traffic, using a control plane policy map, and let only one host access the d...
Hello everyone, I have the network diagram as follows. As r-1 advertise its loopback 0 into BGP, i need this prefix to be reachable from r-5 and r-6. Same for r-2.now, i would like that ASN 1.2 to see only those 2 prefixes coming from ASN 1.1. Now i...
Hello everyone, Regarding ospf summarization, please correct and advise me: area 15 range summary-address mask. this will advertise my summary address from area 15 into backbone. and is done on abr.internet------asbr(area15)-------(area15)abr(area0)...
Hello everyone,How do i overcome the ibgp rule not to advertise a BGP advertisement learnt from one iBGP neighbor to another iBGP neighbor?as in my topology i need router loopbacks advertised via ibgp.all routers have ospf enabled and conectivityall ...
Hi, Thank you all for you answers. It was a my liitle weekend lab to expand my knowledge.The idea was to provide L2 connectivity over an mpls core.This was meant to be the entry point where i get the tagged frames from different carriers and i was lo...
Hello,i found a similar solution to my problem here :https://community.cisco.com/t5/network-management/restricting-telnet-ssh-access-to-loopback-address/td-p/1306161 Thank you all!!
jon indeed you are a legend. you opened my eyes and made me realize my stupidity, and that the traffic i was generating was sourced from outgoing interface of r5 not from loopback as desired. and ofc those routes are not advertised into bgp, silly m...
Thank you for your prompt answer. I am trying to have only one summary route into area 15 from area 0. On the absr which is in area 15 i want to have only the default route towards the internet, and a summary route 10.1.0.0/16 towards my internal net...
