Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is there anything special that needs to take place to Import a PIX 501 (IOS Version 6.3) config to an ASA 5505 appliance or is it as simple as uploading the config?
I have a Cisco PIX with a site-to-site vpn and also client-to-site vpn. I can authenticate to the vpn and connect, however, I cannot access a pc on the internal network via Remote desktop. I have attached my config. Can someone tell me if I am missin...
I have a pix 500 series configured with VPN client access. When I configure a site-to-site vpn to a remote location, the client access no longer works. If I remove the site-to-site vpn, the client vpn works again. I have tried the PDM and the CLI. Co...
I am "simply" trying to allow smtp traffic from the internet through a PIX to my Exchange Server. I could not get this to work, so I have set up a test bed with the following configuration: PIXFirewall# show run: Saved:PIX Version 6.3(4)interface eth...
I think I already have the access-list nonat permit ip 192.168.50.0 255.255.255.0 192.168.51.0 255.255.255.0. Should I just remove the command: nat (inside) 0 access-list nonat?Thanks,GDA
Thanks acomiskey, that was the direction I was thinking about heading. Your quick responses and knowledgeble answers were extremely helpful. Thanks again!!!
