12-08-2008 10:35 AM - edited 02-21-2020 03:09 AM
Is there anything special that needs to take place to Import a PIX 501 (IOS Version 6.3) config to an ASA 5505 appliance or is it as simple as uploading the config?
Solved! Go to Solution.
12-08-2008 11:18 AM
Greg
Not it's not unfortunately because your pix is running 6.4 and the ASA 5505 will be running a minimum of 7.x code and there were quite a few changes. Note that a lot of existing commands would work but some won't. Attached is a link to a doc for upgrading from pix to ASA which talks about both a manual method and a tool assisted version -
http://www.cisco.com/en/US/docs/security/asa/migration/guide/pix2asa.html
Jon
12-08-2008 11:18 AM
Greg
Not it's not unfortunately because your pix is running 6.4 and the ASA 5505 will be running a minimum of 7.x code and there were quite a few changes. Note that a lot of existing commands would work but some won't. Attached is a link to a doc for upgrading from pix to ASA which talks about both a manual method and a tool assisted version -
http://www.cisco.com/en/US/docs/security/asa/migration/guide/pix2asa.html
Jon
12-09-2008 09:25 AM
Thanks Jon, I kind of suspected that. I will take a look at the link in detail and go from there. Thanks again for your help!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide