Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, Question I have two cat4506s connected via an etherchannel. Do I need to enable "qos trust dscp" on the etherchannel interface to get markings from one switch to another? Since it is a trunk shouldnt it already accept the QOS tages and not wip...
Can I mix TRANSCEIVER of diffrent types to connect devices. i.e. Can I connectiona Cat 3560 SFP transciever to a GBIC transciver on a cat 4506 line card?
Hello ALL, I have a Cisco 3640 with a hssi card connected to a adtran T3SU 300. The hssi card is receving lots of input erros and CRC errors. The DSU is receving errors aswell on the local side. My telco tests clean to a loop i Put infrom of the DSU...
Hello, I have two DS3 connections with two diffrent Service providers. Each with thier own CPE router. Now I want traffice to flow equally accross both routers so I will for not just adversite with no prepending. My Question is the return traffi...
The only wic compatibility issue that I am currently aware of is you can not install a Version 1 WIC on the 3800 Series router. The 3800 Series require a Version 2
The above is correct your ASA 5510 only has the Cisco ASA 5510 bundle base. Which only allows for 3 FE ports. Check out the below link for the descriptions of each of the bundles. From the ASDM on the main page on the license tab you can see what you...
