I'm trying to setup a content rule to test load balancing LDAP traffic via the CSS but it doesn't seem to be working. Here's my configuration:service 10.125.5.56:389 ip address 10.125.5.56 protocol tcp port 389 keepalive type script ap-kal-ld...
If the multicast source and receivers are all in the same VLAN then you don't need to configured PIM since that is a multicast dynamic routing protocol between VLANs or layer-3 segments. You will need to configure an IGMP Querier on the VLAN though.
I know this is a 3 year old thread but I have a similar concern and problems with these 4G-LTE-ANTM-D antennas. They are quite delicate and the plastic joint to the connector breaks off quite easily. I've already lost a handful of these out on the fi...