Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have the following equipment on our network.1. Firewall PIX 515e configuration version 6.3(1).2. Router C3759 Version (12.1)3. Router C3700 12.2(15)Can you tell me what happens when an IPv6 packet is send to an IPv4 system?Do we have to enable any...
We are just about to purchase a Cisco ASA 5505 Security Plus Firewall and would like to know the restrictions of useing the 2 POE ports, can they be used as ordinary ports with out this feature ?Can you turn off the POE feature for these ports?Do the...
I have 2 PIX 515e firewalls 1 configured as a fail over unit. Can this license be changed so that i can use them separately? What is the approximate cost of the license change over and what is involved?
Hi, I've been getting the follwoing message on my c2600 (version 13.3) router since last december (according to the log file).005179: .Dec 28 04:35:08.652 AUS: %IP-4-DUPADDR: Duplicate address xxx.xxx.xxx.xx onFastEthernet0/0, sourced by 0015.f987.94...
Hi, I have PIX 515e that i'd like to copy the stratup-config of to another server on our network. Can i use the tftp server to do this? I've tried the COPY startup-config TFTP: etc command but i get an error that says the stratup-config is not found...
The only trouble with that suggest is that this router happens to be in another state. I'll have to try and talk somebody though the trace. show cdp nei does not work for the second device, it must be turned off. If it is a firewall and i change the ...
Thanks. I've finally got it to work. I had to set up the tftp server and also add a access-list entry for the server i was sending the config to. But at least now i can get a config listing that i can study.thanks again
