Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is there any way in IOS to use a ping to a specific IP address as a keepalive? I am trying to implement a failover between two ISP connections without using BGP. I want the connection to switch to the backup if Layer 3 reachibility is lost, not when ...
Is there any way in IOS to use a ping to a specific IP address as a keepalive? I am trying to implement a failover between two ISP connections without using BGP. I want the connection to switch to the backup if Layer 3 reachibility is lost, not whe...
Nothing special on the router. Just make sure that you set a bandwidth statement so that your routing protocols (if applicable), and your show interface counters will function properly.
Nothing special on the router. Just make sure that you set a bandwidth statement so that your routing protocols (if applicable), and your show interface counters will function properly.
Is there a way to perform the same function without the requirement of the ADSL link failing? What if the ADSL link to the DSLAM stays active, in which case the static route out the interface stays up... Suppose the ATM link on the egress side of t...
Unless there is a specific reason why you need NAT on the 17xx router, I would not use nat there. I would let the PIX handle the NAT function and overload NAT on the outside interface of the PIX.As pointed out in the previous response, you need to h...
