Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a 3845 with a fastethernet 36 port module and a gig port. I would like to setup port monitoring for example:monitor session 1 source interface Fa4/2 - 6monitor session 1 destination interface g0/3/0However the command does not accept the gig ...
I have 2 x 3845 router/switches that I have OSPF running on.I want to be able to have layer3 and layer2 (since I have dual card hosts) in an Active/Standby HA. I setup HSRP but it does not provide L2 redundancy. Ideally I would like it to operate li...
Hi, I need to redirect MS Exchange (smtp, pop3, imap4, http, https) ports on a CISCO pix 506e firewall using PDM 3.0 (no CLI). PIX public IP: A.B.C.D, mask 255.255.252, MS Exchange server is : 192.168.105.8, mask 255.255.255.0, gtwy. 192.168.105.1 Al...
Thanks for the reply.There is no other mechanism in Cisco to do this?Also do you have a sample config?I would like it to be an active/standby not active/active. Also how do I link the L2 ports to the HSRP? Basically if I lose a link on port 1 on sw...
