Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiI have a Cisco 877 & 878 ADSL router. I need to configure them in a back to back configuration before they are sent out on site.The problem is, I have never configured any adsl routers before. Does anyone have any config templates I could see ?Rega...
Hi everyone.I'm trying to find out how I can configure a "MAC Access-list" to allow only HP Devices through a switch port.I have never used this feature before and cannot seem to find any examples of how to do it ..Can anyone help ?
I understand how the IP helper Address command works and I know that you can have several IP helper addresses on the one router interface.But, can anyone tell me, does the router transmit to all configured ip helper addresses on the one interface at ...
I have one Cisco Layer 2 Switch with 10 Servers attached. This switch in turn connects to a Cisco Pix 515e Firewall on the inside interface9 of the servers have no problems and can access the relevant services/clients residing on the outside interfac...
further informationwe need away to somehow convert http traffic entering the "inside" interface to be converted to https traffic when leaving the outside interface ...I cannot go into it in any great detail other than it is a goverment security requi...
Hi thanks for that Giuseppe Here's another for you or anyone out there reading this.I have just been informed that one end of this adsl circuit will be a BT ADLS MAX line running up to 8mb and the other end will be a BT SHDSL line providing 1Mb of ba...
Hello Giuseppe Thanks for the help. But both Cisco 877's I have do not support the command "dsl equipment-type co ignore-error-duration 18 "I have looked and cannot find any similar commands. The IOS version on this CO router is 12.3(8r)YI4Any ideas ...
