Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
What would it take to add a second Sup1A to an existing 6509 that is online, and set up redundancy? What commands or additions must be made to the config? What type of downtime if any are we talking?A note to you kind, smart cisco-ites. I am a new...
Our 6509 is full. Redundant Sup1As, 6148 non-POE 48 port gigE cards, 1800W redundant PWR. Can we simply move the cards slot for slot over to a 6513 chassis, or is there some tweaking of the config that is necessary?Ari KlingmanSenior Engineer
I am trying to add a second sup to an online 6500 system. Assuming all the IOS versions etc. match. Can I just add the second sup and add the redundancy commands?Will it come online as standby? Are there any steps I need to take to make sure it ha...
Andrew FYI Also if you zoom in on the interactive model of the 6513 shown on the cisco website. You can see that it is shown fully populated with POE devices using the 1800W power supplies. http://www.cisco.com/en/US/products/hw/switches/ps708/prod...
