Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Good evening.I have a network with mixed MR56 and MR57 APs using WPA3 authentication. I am considering enabling the third radio (6GHz) on the MR57. However, I am not clear on what would happen to my clients when they roam from 6GHz to 5Ghz radio.Can ...
MR56 network, clients are reporting disconnects in multiple classrooms.I'm seeing the following SSIDs when viewing "Interfering APs" in Air Marshal.My APs are on 20MHz (red circles ) channel 44I highlighted in green what I believe could be causing in...
I need advice to limit the bandwidth for our guest users. Meraki school with 180 APs (MR56) 500Mb up down. Question, what would be the best recommended settings to allow a maximum of 100Mb to the guest users without affecting client performance.Curre...
Good Evening, Need help understanding TDR results: The First Test shows:Pair A Pair APair B Pair BPair C Pair CPair D Pair D Second Test Shows:Pair A Pair BPair B Pair APair C Pair DPair D Pair C Why is there a difference between the local pa...
Hi Everyone, Cisco 3800 16.12.4a AP 9120 Flexconnect . WPA2/PSK AES :Some clients (iPads) after they connect loose internet. I checked the client events on the AP and it shows the following: [0a:80:3a:ed:dd:59] <apr1v0> [D:W] DOT11_PROBE_RESPONSE : (...
I encountered a similar issue when provisioning new networks that received firmware version 31.1.5.1 on the MR57 access points.The primary complaint was significantly reduced speeds, averaging between 8-90 Mbps. Upon examining the AP device health, I...
Thanks for your input. We have considered using separate SSIDs however, What I would like to know is what will happen if we stay with the same SSID. Will this create disconnects when roaming?
I completely agree with @DevilWAH1 The issue was originally reported from Chromebook devices disconnecting or reporting poor client experience, eventually all devices with no exceptions were reporting the same anomalies.I also noticed AP performance ...
Last night I downgraded a couple of schools to 28.7 + disabled Client balancing. High density networks, more than 100 MR56 each.So far no complains coming from the users and the logs are clean.Will keep and eye on them and update everyone.
