Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,You can telnet to your switch/router and use the description command like the following example:switch#conf termswitch (config)#int gigabitEthernet 3/4switch (config-if)#description *** Link 2/2 to MUN_BBL_F0_IDFB_SW01 ***thanksWael
Hi,You are right. You can create a channel with ports in different modules. Moreover, it is a good practice to create critical channels ? like that you have ? through ports not on the same module. In this case if a module will go down the link will n...
I have a similar design. According to your explanation you can do the following to allow smtp traffic to be directed to the Anti Spam.IPs:Anti Spam public IP: 67.1.2.3Anti Spam DMZ IP: 172.168.1.41PIX internal IP: 172.168.1.11- The Default Gateway fo...
