About mfuerni

mfuerni · 12-19-2020

Hello Community, I use three SG300 switches to run my network. One is connected to a (free) ESX server running an OPNsense VM that acts as router. I have several VLANs that are connected using trunks between the switches and ESX. The OPNsense VM is c...

mfuerni · 12-28-2020

@paul driver wrote:Okay if its possible you could use two ports, one for the promiscuous port (access-port) for the server and another port (trunk) for all other vlans?Hello Paul,I hoped there is another, more elegant solution without 'wasting' a ded...

mfuerni · 12-28-2020

Unfortunately, on my SG300 only the following commands are available in interface configuration:sw1(config-if)#switchport mode private-vlan ? promiscuous private-vlan promiscuous port host private-vlan host port sw1(confi...

mfuerni · 12-26-2020

Hi Paul, thank you for your response. I'm aware of basic PVLAN configuration. My problem is the promiscuous port which goes to the firewall: It is a trunk from one switch to the hypervisor and an additional trunk from the hypervisor to the OPNsense V...

Member Since	‎12-19-2020 06:01 PM
Date Last Visited	‎01-03-2021 10:47 AM
Posts	4
Total Helpful Votes Received	5

User Statistics

User Activity

PVLAN and Trunk on SG300

Re: PVLAN and Trunk on SG300

Re: PVLAN and Trunk on SG300

Re: PVLAN and Trunk on SG300