Am a little bit confuse as to the differencen sfp and GBIC.I have also come across gigabit Stack gbic. Any contribution to make this clearwill be appreciated.CheersJitez
Hi All,I have just configured a 2950 to be a client, is there a way to change this back to server or transparent.I did tried to by entering vlan database, but it will not go onto vlan config modeAny help will be appreciatedthanks
HiExtended Acls will also check for sepcific protocols i.e tcp, udp, igmp,icmp,rip,etc and again check for both source port and destination port numbers as you may wish to specify.Hope this helpscheerspaul
I may not understand the context from which you may be asking, basically a few parameters must be same on routers runing ospf for ajacency between neighbors to occur1.hello interval2.dead time interval3.same subnetI hope this helpspaul
Vlans will be propergated from server to client mode and transparent mode,however transparent mode will only forward the vlan infos and will not process them, so you will not see the vlans in the c2821.All switches should be Linked by a trunk configu...
Hiplease what is the pinout for 1000BaseT i.e gigabit over ethernet cable connection.guessing it may be like pin 1-4 send, pin 5-8,receive.Thanks in advance.paul
