Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,,i have issue with my environment with standby IP address,,MY LAB as Follow :1- Two FTD 2110 works on the HA group successfully, 2- Enable Standby IP address on all interfaces the issue when switching over the node is the standby IP will work i...
Hello All.. i have 2 Cisco C9300 works on StackWise,,, i have a question about the license,, both switches come with an essential DNA license, so I try to use the following command license boot level network-advantage addon DNA-advantagereload,, the ...
Hello..I have to ISDN E1 Interface on Cisco Router 2951, each E1 have a different phone number,, and i need to configure a 2 SIP trunk between router and 3CX system,, each phone number connected to a dedicated SIP trunk,, because each SIP trunk will ...
Hello. I have a cisco router 2951 with 1 PVDM32, and I have 2 E1 each E1 connected to a different phone number, I have a question about dividing the 32-time slot between 2 E1. the current configuration :controller E1 0/1/1pri-group timeslots 1-16des...
Hello everyone,, i have Cisco 2900 running as a VOIP gateway that connected to E1 interface that provide ISDN service ,, and connected to the 3cx server as SIP gateway,, i need to add another E1 interface to use another voice number ,, so how i can...
I Ask the ISP today, told me both E1 timeslots are configured from 1-16,, so can I use the following commands? controller E1 0/1/1pri-group timeslots 1-16description ***!controller E1 0/1/2!controller E1 0/1/3pri-group timeslots 1-16description ***
I Ask the ISP today, told me both E1 timeslots are configured from 1-16,, so can I use the following commands ? controller E1 0/1/1pri-group timeslots 1-16description ***!controller E1 0/1/2!controller E1 0/1/3pri-group timeslots 1-16description ***
