Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have an access point with a 100' low loss cable (CiscoAIR-CAB100ULL)connected to an Cisco AIR-ANT2506 5.2dB Gain Omni antenna. I can stand right next to the antenna and I see only a 1bar signal strength using Windows Zero Config tool. It seems o...
Is there any way to block a specific mac address from connecting to a specific SSID using the a Wireless Lan Controller 4400? I want to prevent my corporate users from connecting to our guest network which uses web auth. I cannot do an allow mac li...
I have been trying to set up a radius server on a WLC controller. If the radius server's IP address is on the same subnet as the management (non-vlan) interface then radius works fine. I created a new VLAN interface in the controller on a 10.0.203....
I am seriously stuck. I have spent the past week trying to get EAP-PEAP MSChap to work using a WLAN 4402 controller. I cannot find any documentation on how to propperly set up the WLAN controller to do this. I have gone through over 500 pages of mi...
I tried testing a different cable, a different AP and I also changed antennas and used Left instead of right. I don't get it, I must be missing something. Any other Ideas anyone?
FYI, I ended up resolving this issue. The issue was the fact that I was using a Standard Switch. I purchased a Layer2 Managed switch and got rid of the firewall and I was able to do everything I needed.Thanks, for your help
To test the settings on the RADIUS server, I left the IAS Radius server settings untouched. I re-configured the WLAN controller and set the same IP's up as untagged (rather than on a vlan) and authentication works fine using this RADIUS server. Whe...
