Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have two Secure ACS appliances - primary and a secondary. The secondary is behind the firewall and so we have the IP addresses nat'ed. I can get to the sec appliance via the natt'ed Ip address, but it the primary server says he does not see it. bel...
I have 2 t1 CSU/DSU WIC card in cisco2800 and cisco2651 XM. This is my fisrt time doing this. Can you please specify which cable exactly I shd use:Frame-relay switching is enbaled on both routers globally...below is my config interface Serial0/0 des...
Below are the messages I am getting, At the end of teh log you will see where the call suddenly gets dropped. Jan 9 19:20:31.348: BR1/0:1 LCP: AuthProto CHAP (0x0305C22305)Jan 9 19:20:31.348: BR1/0:1 LCP: MagicNumber 0x17107D0B (0x050617107D...
Can someone assist with ISE radius authentication for APC This is what I have so far- Imported the dictionary for APC- created a Authorization Profile- Added APC as a network device on ISE- made sure secret key is the same thing on both APC and ISE B...
Can someone assist with ISE radius authentication for APC This is what I have so far- Imported the dictionary for APC- created a Authorization Profile- Added APC as a network device on ISE- made sure secret key is the same thing on both APC and ISE B...
Vivek, Thanks for yor response.Oops. Sorry about that. below is the link I was give:http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a0080742f60.shtml#configure_db_natI am currently running CiscoSecure ACS v3.3...
