Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Was wondering if anyone else experienced this issue:Currently have a WLC4402 installed with 21 AP's reporting to it. The controller is running at LWAPP3 with version 3.2.116.21. The WLC was purchased prior to Cisco buying Air-e-space, and has a 36 AP...
Just curious, as the documentation for the WLC 4402 states "Note The Utility Port (1000 Mbps Ethernet, RJ-45) is not currently used and is reserved for future use.".It would be great if CISCO could notify WLC customers about when and/how this port ca...
I have a WLC 4402 that I am using in a wireless testbed. During the initial configuration, I followed the basic configuration guidelines for the L3 LWAPP. Tried to configure the Service-port without an IP(0.0.0.0), but it would not accept it(msg."Ser...
Hi, I am setting up a WLC2006 with 2 AP1010's. I cannot get the controller to see either AP. When I place the AP's on a network with a WLC 4400, they are recogized immediately by the 4400 at Layer-2 LWAPP. Since the WLC2006 only works at Layer-3 LWAP...
Rob,Thanks for the link info. Saved me a lot of time & headache. Found out that the AP's we want to add are AIR-AP1242AG-A-K9's. They will only work with the WLC 4400 & 2000 series controllers.The controllers currently installed on our LAN are 4100 s...
I worked in a Nortel/CISCO environment where we tried to perform the same scenario in a lab setting. After exhaustive configuration changes and testing, it was determined that VRRP and HSRP would not work together. They are based on different protoco...
