Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have BE6000 installed with CUCM 10.5. I need to activate the paging on this system for all registered pones with this CUCM. Is it possible to do that without a third party software??. Please help me on this.
I am using cisco BE6k and 2911 router, my analog lines are connected with cisco 2911 and i am using SIP protocol to connect between BE6K and 2911. The dtmf digits not passing from BE6K through router Cisco 2911. Can anyone help on this please.
I have BE6000 and CUCM is installed on it. I have 7 PSTN lines connected to a Cisco 2911 router. The cisco 2911 router passes all the incoming calls to BE 6000 and then BE 6000 to the ip phone. I have problem while dialing an autoattenndant enabled P...
thank you for your immediate reply. Is there anything need to be done for multicast in the default switches??. I have installed and configured InformaCast but its getting busy tone when i dialing to CTI route number..
