Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,
I have a new deployment using 9166. 6 GHz are not yet available in our regulatory domain so the 9166 is default to 2 x 5 GHz radios (slot 1 and slot 2), with slot 1 operating in UNII1 and 2 and slot 2 operating on UNII2E and 3. This "band loc...
Hi all,
I am still learning my way through the ACI, just want some help with regard to EPG learning IP addresses outside it's BD. Our ACI setup is 1 subnet per BD and 1 BD is associated with 1 EPG. I was migrating a host physically from our old netw...
@russell.splain Thanks for the insight. It is really helpful to know that it is not a configuration problem on my side that caused this band locking behaviour to remain, even when operating a single radio only. I will follow this up with TAC. Thanks ...
I am in New Zealand and same here, I have no plan in deploying 17.12.x any time soon.
So that leaves me operating in dual 5 GHz with the band restriction on slot 1 and slot 2 as per the deployment guide in my original post. Which is fine and that is ...
Sorry, I should have included this detail in the original post. It's on 17.9.3.
I am trying to get a TAC case logged as well, but that has to go via our customer and in turn their other partner. Thanks.
Hi Nathan and Jason,
I did end up logging a TAC case but unfortunately the logs on ACI rolled over so the TAC wasn't able to find out the root cause.
It was indeed a 3825 router attached to that particular EPG, however that is a voice router for in...
