Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
So I booted into the cisco firepower console using a asasfr-5500x-boot-6.4.0-1.img and then tried installing the package using asasfr-sys-6.4.0-102.pkg. When I tried using my ftp server to transfer the file and install it I got an error saying:Packag...
I was told to configure firepower for our cisco asa 5525-x and thought i'd have to install a module, but this guy is telling me it's embedded into the firewall.. I haven't found anything on how to configure this though and am confused on how you woul...
I'm trying to set up multiple subnets on different layer 3 switches to the internet and I'm not able to get it working. The directly connected Layer 3 3560 cx Cisco Switch is able to ping the Netgear Nightawk RAX80 router interface and 8.8.8.8 as wel...
In this diagram I'm told to set up 10.10.0.1/16 on interface vlan 1 and ping all other hosts with different network addresses. I have ip routing enabled and when I create a static route or dynamic route they don't show up in the table but I don't get...
I'm a little confused so I have one host that is 10.10.0.100 on vlan 1 with an SVI of 10.10.0.1/16 and I'm trying to ping vlan 100 with ip address 192.168.70.150 and an SVI of 192.168.70.1/24. The way it's laid out is I have a layer 3 Cisco switch di...
In this diagram I'm told to set up 10.10.0.1/16 on interface vlan 1 and ping all other hosts with different network addresses. I have ip routing enabled and when I create a static route or dynamic route they don't show up in the table but I don't get...
