Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
There seems to be some confusion as to what exactly you call the different address sections of an IPv6 address. The parts between the ':' delimiter. Or, the equivalent of an 'octet' in an IPv4 address.I hadn't realized until I stumbled across this ...
Hi,Before I purchase a SG300-20, I need to clarify something I haven't been able to find in documentation or by playing with the online emulator.I need to be able to disable all switch generated traffic, STP BPDU's, LLDP, CDP (future), etc. packets o...
I am working with a common home router configuration on an 881, and adding an IPv6 tunnel for native IPv6 on the inside. This is the design I'm working from:https://supportforums.cisco.com/docs/DOC-15565I am trying to come up with a zone based firewa...
This is an example configuration for connecting to the Comcast 6RD trial tunnels from a typical residential NAT/DHCP home router.NOTE: Comcast has listed an end date of 6/30/2011 for their 6RD trial. The 6RD gateway may not be accessible after that...
Hi,I have a new 881 router loaded with the latest 15.1.3T software, and I'm trying to get it connected to the Comcast 6RD IPv6 routers. (I'm on a Comcast cable modem.)I've been trying to follow the directions from these links:http://docwiki.cisco.co...
Apparently the -08 versions of the SG200 do not support SNMP or CDP, or many other things that the other SG200 series running 1.3 software do.I just bought an SG200, and I'm really annoyed by this. If it had been more clear I would not have purchase...
Thanks. I'm glad to hear that is a normal output. And thanks for the info on the additional commands. Of course, more commands lead to more questions. The 'sho mls netflow ip detail nowrap' does not seem to show anything except multicast and br...
Is there any way to monitor the behavior and operation of a VLAN-based micro-flow policer on a 6500 switch? I'm using the Medianet 4.0 Design Guide as a reference. However, when trying to monitor the traffic counts, it appears that the micro-flow ...
Hi,Yes, QoS is enabled on the switch, and there is a fairly extensive port based marking/policing policy active on the edge ports, modeled on the Medianet 4.0 guidelines.The cos-map is default as well: Cos-outputq-threshold map: cos: ...
I have a question on 3560/3750 threshold counters.This is the default DSCP output threshold map, from the 'show mls qos map' command:Dscp-outputq-threshold map: d1 :d2 0 1 2 3 4 5 6 7 8 9 --------------...
