Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,After the configuration of NAT, my webserver (1.1.1.4) is not accessible anymore from outside (4.4.4.2).ICMP is working, but browsing is not.The problem must be a bad ACL configuration.I tried various configurations, extended ACLs, just to allow a...
Hi,I'm trying to understand VLANs and trunking.This (screenshot) is a working router-on-stick example with 4 VLANs.V40 is native Vlan 40 (ADMIN, manage)All gig1/1 & gig1/2 interfaces are trunks.My question is about the output of S1#sh int gig1/1 swit...
Hi,I have a question about OSPF, default route distribution and the network statements.This is an exercises from my CCNA class, see attach for the setup.Between ISP and Router A1 we have to use a static route, default route => ISP.Network A1 - A2 - A...
In your output above, te "Access Mode VLAN" is the one the port would be on if it were in access mode. But that is irrelevant, because it is not in access mode; it is in trunk mode.That is all I needed to know. It's clear to me now.Thx a lot.
