Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,Here I'm configuring 5 routers.There are three areas RIP V1, RIP V2 and RIP V1.How can I configure RIP V1 & RIP V2 in same network.Here I attach the routers diagram that to configure.
In this case,I want to configure R4 as Frame-relay switch.R1 uses DLCI 102R2 uses DLCI 201USE IETF encapsulation (rfc 1490)Ensure both DTE do not build dynamic address mappingEnsure the broadcast packets are replicated on the frame relay linkEnsure t...
