Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
G.SHDSL can be configured back-to-back over ATM. See link below. Can you configure G.SHDSL back-to-back over ISDN.I want to connect 2 CISCO878 back-to-back but the dsl commands are not on the router.http://www.cisco.com/warp/public/794/dsl_cpe_config...
Hi I’m experiencing problems installing an IDS on CiscoWorks2000 Management Center for IDS Sensors. When I add a sensor I get the following error “Error importing configuration files from the sensor - Could not find version in string "Unknown version...
Hi I have got a PIX 520 that I cannot seem to get working. The following message is displayed. Any ideas what the cause could be. Cisco Secure PIX Firewall Version 5.3(2) open(ffsdev/2/read) failed An internal error occurred. Specifically, a programm...
Hi I have got a PIX 520 that I cannot seem to get working.The following message is displayed. Any ideas what the cause could be.Cisco Secure PIX Firewall Version 5.3(2)open(ffsdev/2/read) failedAn internal error occurred. Specifically, a programming...
Hi formCan you have both DNS servers (primary and secondary) on the inside interface of the PIX firewall with a private IP scheme (192.168.x.x) ?I have trying to do this but the DNS server are timing out when resolving name to IP address resolution –...
Hi, not to worry I got it working.I have included my configs CO router config Current configuration : 1308 bytes!version 12.4no service padservice timestamps debug datetime msecservice timestamps log datetime msecno service password-encryption!hostna...
HiThanks for the help. It worked fine up until I reinstalled ciscoworks2000 on a new box.Now I’m getting the following error. C:\Program Files\CSCOpx\MDC\bin\ids>plink -ssh netrangr@sensorFATAL ERROR: Incorrect MAC received on packetAny idea how to f...
Hi allI have found the answer in the PIX FAQs. Thanks for you help.Thomas If you have your own DNS server inside your network, this obviously won't work because the DNS lookup never transverses the PIX, so there's nothing to fix. In this case, config...
Thanks for the info. All the devices are supported in path analysis. What I have noticed is that if one of the end devices is a router then it shows all the switches in between – layer 2 and layer 3. As soon as you only do a path analysis between onl...
