Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,i'm wondering about an interface on an ASR920. GigabitEthernet0/0/7 is up, line protocol is up
Hardware is 24xGE-4x10GE-FIXED-S, address is XXXX.XXXX.XXXX (bia XXXX.XXXX.XXXX)
Description: *** XXXXXXX ***
MTU 9000 bytes, BW 1000000 Kbit/sec, DL...
I'm looking for a way to monitoring the usage of an IP-Pool on Cisco ASR9000.
Until now we are using ASR1000 with SNMP:
- cIpLocalPoolFreeAddrs (1.3.6.1.4.1.9.9.326.1.1.2.1.5) CISCO-IP-LOCAL-POOL-MIB
But i'm unable to find a equivalent OID on IOS...
Hello,is there a way to configure RFC3069-Support on ASA 5500-X? I would like to do this: http://www.gossamer-threads.com/lists/nsp/ipv6/25933But i would like to add some firewall support (ACLs and so on) . Best regards Harald
Hi all, i'm trying to get online with IPv6 with my Cisco 886. But i failed. Perhaps you have any hints for me. My Config: interface Dialer0 description *** IPv6 *** no ip address ip flow ingress ip virtual-reassembly in encapsulation ppp load-int...
Hi,is there a working L2TP/IPSEC VPN solution between Cisco IOS and Android 2.1?I'm trying to get my mobile online, but the connection is terminated after 10 sek.Any hints?HaraldMy IOS config:vpdn enable!vpdn-group l2tpvpn! Default L2TP VPDN group ac...
I don't know anything about the connected device. (Customer equipment) show version:Cisco IOS XE Software, Version 03.18.03.SP.156-2.SP3-ext
Cisco IOS Software, ASR920 Software (PPC_LINUX_IOSD-UNIVERSALK9_NPE-M), Version 15.6(2)SP3, RELEASE SOFTWARE ...
Hi Cassian,i hope i didn't miss anything, :!---------------------------------------------------vpdn enable!vpdn-group l2tpvpn! Default L2TP VPDN group accept-dialin protocol l2tp virtual-template 1 no l2tp tunnel authentication!username user privil...
Hi Laurent,if i change the dialer interface with "ip address negotiated" the probelm is still existent.Furthermore i'm still wonding about the same config which is working on Cisco 836.I'm using: "c880data-universalk9-mz.151-2.T3.bin"RegardsHarald