Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I read that if I wanted to setup a scheduled restart of the services, I can do this using a Cron job. The problem is that when you look for ncs in the shell, there is no executable. If I run "systemctl restart NCS", that doesn't restart the depen...
Hi Guys, I am replacing a secondary supervisor module in a 9410R and I can't see anything in the documentation in terms of commands that are needed once the supervisor engine has been installed.I believe that the active supervisor will cascade config...
Thanks, Richard. How would I be able to check the reason for the failure or any logs on the failure from the device itself?The switch only has 1 supervisor, not sure about how many processors it has. I checked the Data Sheets and documentation, but I...
This is a N3K-C3172TQ-10GTThe command above is not applicable to this device:Switch# show logging onboard switch <> uptime detail ^% Invalid parameter detected at '^' marker.Switch# show logging onboard ...
Thank you both for your replies. Can you please confirm if I need to use any commands to change the configuration, or will it definitely cascade down from the active sup? Thanks
How is the system uptime vs system restarted different?SWITCH# sh ver ...SWITCH uptime is 12 weeks, 1 day, 23 hours, 25 minutesUptime for this control processor is 1 day, 4 hours, 20 minutesSystem returned to ROM by SSO Switchover at 10:03:48 UTC Wed...
No reply to this for a long time, but I wanted to share that I have the same issue and we have 5000 APs... You can imagine the amount of alerts we get, right? I hope they find a solution to this, as I've seen other people with the same post on here...
