Hi all,Is there an available snmp trap for monitoring cpu load on the 4510?If yes, what's the string to be used to catch the value? And is SNMPv2c good enough or does this require v3?Thanks!!!
Hi,we've recently done some restructuring on our network and the 2950 in our room is now fed from a 3750 switch (instead of another switch we had) and since then the management on the 2950 seems to be dropping off all the time. network connectivity w...
i'll TRY TO post the configs when i get back to work, no remote access to the switch since i dont have connectivity to it over the management vlan. (same problem im trying to fix!)
we did not change the ip of the catalyst 2950 after the change and again the only change made was it was moved from being fed by an enterasys v2 switch to the new cisco 3750its fed from a fastethernet port on the 3750 to a gigabitethernet port on the...
they are trunks, and both are config'd as trunks with the management vlan tagged to the port.like i said, connectivity is 100% up, so i dont think that's a vlan or trunk/access port config error... but im not the smart one here so im open to suggesti...
all switches on the network point to one dhcp server and one default gateway, so im not sure that may be the issue.normally when doing these changes during relocation, all that needs to be done is ensure that the ports are configured as auto negotiat...
