Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have a management network that has 192.168.148.0/24 IP range. Also I use 192.168.148.0/24 (braked to small subnets) for L3 p2p connections. I use eigrp (AS 1) for routing these addresses. For routing between the other networks I use static route...
Hi,I am trying to create one loopback interface on each network devices in our LAN. For example 192.168.50.1/32 for one device, 192.168.50.2/32 for another device and so on. These ip addresses will be used for management purposes. So the 192.168.50.0...
Hi everybody,There are a lot of input errors on one of VLAN interface. I don't know waht's the cause of these errors.The result of Show Interface is attached.
An enterprise composite model includes :-Server Farm-Campus Backbone-Users VLAN-Edge Distribution-DMZ-etcHow we can build a Management Block for all the enterprise? Can we have one management VLAN for all enterprise? If the answer is yes, as far as c...
Hi Guru,AS 1 is not used for routing between CE and PE.I explain more about the Management Network:We have different networks that are connecting via L3 point to point connections. To manage the whole network, as you said, using SNMP, CiscoWorks etc,...
I did a test. I remove the p2p network from EIGRP configuration and added 1 static route on each router.After that I can't see EIGRP routes in the routing table.By the way routers are directly connected