Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,We have a Cisco Cisco Webex Codec Plus that we need to enable ports for on the Cisco ISR 4300.Not sure if anyone has experience in this and what ports I need to allow (inbound and outbound) for Cisco Conference Room kit with Teams and Skype fo...
Hi All,We have a couple of Infoblox Grid (Active/Passive) each located separate DCs.The loopback interface is configure on same subnet as physical Interfaces. Example : -Loopback 192.168.10.5 (VIP)Phy1 DC1(Active) : 192.168.10.25,Phy2 DC2 (Passive) :...
Hi All, Just looking for advise , pros vs cons about connecting an ISP internet feed directly to our core mpls/vpls switch. ISP Internet Router—>adva—>Core Switch(siteA)—>mpls/vpls—>Core Switch(siteB)—> Palo Alto The PA firewall will have a separate...
Hi Paul,Not too familiar with Infoblox loopback setup. I only know it from a switch/router where the loopback interface can be configured. So each time the .conf file needs updating when the ip is moved ? Do you have any information or docs to con...
Hi BB,The switches are layer2. The solution at the moment is not to use HA but just failover and manually configure .5 IP on loopback interface of new Active at DC2.The loopback interface has no mac adress associated so should be routed fine.Any re...
Hi BB, The Core that will be used for connecting the ISP link has inter-site connections to other sites. We have no MACSEC I think that would be difficult to implement at this stage , I have never seen this implemented anywhere.
Hello Georg, Yes thats what I am being told but unfortunately its not possible to reduce hop count to firewall. We are using centralised firewalls. If I have a point to point static route to firewall is that not acceptable?
