Hi,
I've got a 5624Q that I need to trunk over to a 3850 via 1G SFP fiber for external connectivity. I was told by presales that this could be done using a CVR-QSFP-SFP10G adapter with a GLC-SX-MMD installed into it and another GLC-SX-MMD installed...
Hi Preanda,
Yes, I got the link to come up and was able to trunk over to my 3850.
The only unfortunate side effect is I had to waste 5 additional ports on the 5k to make this work - i.e. I had to set all 6 of the ports to 10G instead of just one.
N...
While waiting around for TAC to get back to me, I discovered the breakout command.
Here's what I was missing. I needed to use the following command;
interface breakout slot 1 port 7-12 map 10g-4x
Then I was able to set the speed on the port to 1000 ...
Thanks for the info. This is what I see on the port with the sho int command;
s01# show int e1/5Ethernet1/5 is down (Link not connected) Dedicated InterfaceHardware: 40000 Ethernet, address: 8c60.xxxx.xxxx (bia 8c60.xxxx.xxxx) MTU 1500 bytes, BW 400...
Hi Preranda,
Thanks for the info. See that's the thing, the doc you reference above, does show my situation as an acceptable solution.
Table 8. Cisco Nexus 5600 Platform 1 and 10 Gigabit Ethernet SFP and SFP+ Transceiver Support Matrix
Cis...
