Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am editing the config of a 1712 remote vpn when I destroyed and recreated crypto map. The change I made took. No problem, but the old map still remains. This the config:no crypto map VpNmAp 27 ipsec-isakmp crypto map VpNmAp 1 ipsec-isakmp set peer...
I have just been hit with a loopback interface scheme at a new job. I do not quite understand it that much, since it is very different from loopback addressing of 127.0.0.1 Could someone tell me more. How is it used? what is it used for? You could al...
Cisco 1721 router is connected via ethernet ports to a 2611 router with these ip addresses:10.10.10.2/30 and 10.10.10.1/30. The 2600 is connected via ethernet port again to recieve dhcp address - 192.168.1.40/24 from a (PIX firewall testlab - 192.168...
What am I doing wrong? I am unable to capture text in Hyper Terminal and save it to notepad. First I highlight the text. then go to menu >transfer>capture text>filename.txt. When I go to open the file it would be blank. Is there any precise way to do...
Thank you guys. I found a way to do it. First I deleted the ipsec-isakmp at the end in a note pad, the did a not "no crypto map VpNmAp 27"That took care of it. It was a pain.
router eigrp 192network 10.10.10.4 0.0.0.3no auto-summary - has solved the problem. Now i can ping 192.168.1 network from 10.10.10.5.However, I am still unable to ping any addresses from the loopback. This is ip route from 1721:Gateway of last resort...
Yes, I have added the static route but no luck still. Here is the config for 1721:1700test#sh runBuilding configuration...Current configuration : 851 bytes!version 12.2service timestamps debug datetime msecservice timestamps log datetime msecservice ...
