Hi Group,I have one Cisco 4500 with two ether net interfaces.It is 10base-t port. My requirement is, I want to limit the bandwidth in eth0 as 512kps. How can I do that in Cisco...regds,

Hi,I have two cisco 4500, one at location A and other at location B. I want to take one leased line from location A to B. I have some doubts in IP assigning to the serial interfaces. I want to route the IP block 150.4.191.64/27 to location B. How I ...

Hi ,I would like to know the step by step configuration of NP-CE1B in Cisco 4500 router. I tried in cco.cisco.com. Any help in this regard would be highly appreciated.The equipments what I have are Cisco4500 router with NP-CE1B module, where the cha...

I have one Cisco 4500 with 6 Ethernet, and 8 serial port. It has only 32mb dram. (2*16mb). Now I wan to run BGP in this router. So for that I need min of 128mb memory. It has only two memory slots. Is it possible to upgrade that to 128mb. Will it tak...

I have one Cisco 4500 with 8 serial port and 6 Ethernet port. From the Ser0 and Ser1 I have two connectivity to my upstream provider. But one is of 2MB and other is of 1MBSee the configuration of 2 of LAN interfaces and ser0, and ser1 interfaces...