Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HelloI am a CCNA. I want to get information about Is there any kind of certification of IPv6.If so kindly informed me about this.Thanx in advanceFrm: Athar
Hello i m athar.I want to know that what r the adjacent routers in OSPF.or what is an adjacency relationship.Can directly connected routers only have this type of relationship in ospf or not?Thanx bye
hello!I have 6 public ips and six ip cameras in my company.i want to map these ips in my cisco ASA-5520 against the private ips used in my company.What is the command and procedure for this?Thanx in advance.Athar
hello!Could it be possible to configure two outside interfaces using 2 live IPs from each ISP and then apply redundency on them.Means if one link down frm ist ISP then second link (frm 2nd ISP)automatically up.What will be the static route scenario i...
here is the configurationnat configurationnat (inside) 1 ppp.ppp.ppp.ppp 255.255.255.255global (outside) 1 ggg.ggg.ggg.ggg route outside 0.0.0.0 0.0.0.0 ggg.ggg.ggg.ggg 1"""where ppp is our private lan address and ggg is our global ip address"""ACL i...
actually we r using PAT means we have one public ip and we use the syntax"nat inside 1 192.168.10.1 255.255.255.255"so my question is can i apply an acl using host 192.168.10.1 as my destination address
i have tried all these procedures and key combinations but they don't work.if in a case its break is disabled in the configuration then what to do in this scenario....
Hellothe main problem is that i want to BREAK the console password for cisco 7000 R.As there is no ip configured, 'telnet' solution is failed.What is the key combination to put an interupt during the boot process.Thanx in Advance......
