Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
My router is able to ping the internet via IPV6exulanit-router#ping 2606:4700:4700::1111Type escape sequence to abort.Sending 5, 100-byte ICMP Echos to 2606:4700:4700::1111, timeout is 2 seconds:!!!!!Success rate is 100 percent (5/5), round-trip min/...
I'm a bit of a newbie with this Cisco stuff, so bear with me. I have set up port forwarding as follows:ip nat inside source static tcp 10.38.48.21 28919 159.196.177.138 28919 extendableI do know that UDP works since I can connect to all applications ...
I am with Aussie Broadband in Australia, and they distribute additional IPs in a somewhat odd way. Aussie Broadband issues the primary address through DHCP, and then the additional IPs you lease are frame-routed via the primary. It's almost like you...
I see, I reverted it back to what you recommended.exulanit-router#show ipv6 int gi0/0/1GigabitEthernet0/0/1 is up, line protocol is upIPv6 is enabled, link-local address is FE80::56A2:74FF:FE64:CA61No Virtual link-local address(es):General-prefix in ...
So I changed it to what you said and it still wasnt working, All devices lost connectivity to the internet via ipv6interface GigabitEthernet0/0/1ipv6 address prefix-from-provider ::15:0:0:0:1/64ipv6 enableipv6 nd autoconfig prefixipv6 dhcp server Mai...
Thank you, ipv6 internet connectivity its now working on devices connected to my g0/0/1 interface but the devices on the vlan 88 g0/0/1.88 interface are not getting an IPV6 address.ipv6 unicast-routingipv6 dhcp pool Server_Network_IPV6prefix-delegati...
