Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
i had a BGP peer and we want to use MD5 authentication in between. I'm 100% sure we use the same password, but I keep recieving the "Invalid MD5 digest" message from the peer. Don't know what's going wrong. anybody has an idea?
I tried to have a NAT enabled on my LAN. IP address of my PC is 10.10.0.183. Outside interface is 66.x.x.18/30, which is connected to my Internet router with IP address ending with .17/30. The configuration is like the following. However, I cannot go...
i have a 6509 (version 12.2), and have some customers with static ip addresses. I need to mirroring the traffic from these customers and send to a hardware filter. Is using SPAN function the only way to do that? I tried to do that on a BigIron layer3...
I'm using a 6509 and need to enable frame-relay switching on the platform. However, after I set up the interface configuration, I canot find the "frame-relay route" command. I did enable "frame-relay switching" in the global configuration mode.Thanks...
I'm moving a VPDN setup from a PIX to a Cisco2801. However, what's the equivalent commands on 2801 to the following PIX commands:vpngroup 1 dns-server VTelEXInside VTelNTInsidevpngroup 1 split-dns vermonttel.comvpngroup 1 idle-time 1800vpdn group 1 c...
we found the problem. my bgp peer has a traffic shaper in front of his router, that device will change the tcp sequence number which leads to the failure of the authentication. he didn't mention that at the beginning. Thanks anyway
actually I'm the ISP itself.I tried that command at the very first step because it's the most straightforward way you can come up with. but it didn't work.is there any conflct if I use both overloading and static NAT on the same interface?
Even though it's shown that my PC got NATed, I cannot browse the internet, I cannot visit any website, no ping, no traceroute. It right stoped at the NAT router. I can ping the outside interface address, but no further than that.what could be the rea...
Yes, I did have the DNS configured and try using an IP address instead of name, but not working.The IPSec is for something else, it just works fine, long before I tried this NAT. I didn't post the crpto congiguration since it's totally unrelated.As y...
