go to previlleged modeif u have TFTP then write this commandrouter# copy run-config tftpit will copy your running configuration into system in the format of .cfg and you can view in notepad and then print itHope This Helps

Hianswer is herehttp://www.cisco.com/warp/public/105/admin_distance.htmlHTH

HiSwitches and router's password recovery function is different and so its not possible to change config register value in global mode of switch because switch doesn't support it. The thing you can change the password or Config register value is to r...

hiJust off your switch and press the mode button while pressing mode button start the switch again and keep your finger pressed on mode Button ( Mode button is present in front At Left Hand )Now release the Mode button after 15 to 30 seconds Now foll...

HiJust replace Ox2142 with 0x32 and then check ityour problem will solve