Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Has anyone seen the problem described below?I have a Cisco 1700 series with two ethernet interfaces (Ethernet and FastEthernet) and a VPN interface module. The ethernet interface is connected to a DSL modem with static IP address assigned to it. Th...
Can someone tell me what does the attached debug output statement entail? I tried to configure a VPN connection from Windows 2000 client using the native L2TP/IPSec to connect to the PIX via transport mode. I also configured the PIX to use IKE with ...
Hello,Does anyone know a good Cisco documentation on how to set up the PIX 515E and Windows 2000 client for VPN access via L2TP and IPSec? I found some okay documents. They are not too good. Kinda confusing. They only talk about setting up the PI...
Does anyone know of a good documentation on how to configure the 3500 XL series switches for voice traffics prioritization? Would appreciate the info. Thanks.JD
Hello,If anyone can help me with this, then i would appreciate it.I have a 515E PIX with 3 interfaces and IOS 6.2. I am trying to configure port redirection for one of my internal servers but it does not work. See the below configuration.static (in...
The access lists are not long. I have 4 access lists. They total up about 40 lines. The volume of traffic going out through my link is insignificant. I tested it with only one user doing nothing but surfing the Internet, and the latency is as hig...
I already checked with the ISP. They tested the line with no problem seen. The weird thing is that if i connected the DSL modem directly to my laptop, then the latency is not seen. It worked great like this. However, as soon as i connect the DSL ...
Thanks for the link. I tried the configurations with pre-share key instead of using CA, and it didn't work.Has anyone successfully implemented a VPN tunnel between a Windows 2000 client and a PIX 515E ver 6.2 using L2TP/IPSec, pre-share key, and dyn...
Ok. So here is the pix configuration that i used. Thanks.PIX Version 6.2(1)nameif ethernet0 outside security0nameif ethernet1 inside security100nameif ethernet2 dmz security50fixup protocol ftp 21fixup protocol http 80fixup protocol h323 h225 1720f...
Thanks for the info. I got some good documents that i can follow up.I still have one more question perhaps you can help me with this one also.I have a 6000 series multilayer switch with multiple gigabit ethernet interfaces (say a total of 3 ports: p...
