Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
in layer 3 mode we will use as discussed before we will use mgmt profile (either it was 10 or 20) for esxi mgmt host vmkernel. the VSM will be on vlan 10 to communicate to VEM in vlan 20 it will bypass through firewall which is vlans gateway , so wha...
so when we use mgmt vlan as data vlan (for network server or test server) we will create 2* vEthernetone with system command will be attached to vmkernel and the other will be attached to vm trafic ?You can use the same veth profile that you will use...
Check with sh int bri if port is in error disable, if yes, maybe is the verification of cisco part number of gbic.I dont know if it work in NX-OX, but in IOS you solve this with the command bellow: no errdisable detect cause gbic-invalid good luck
I dont have knowledge in data domain, but you can directly connect storages and network appliances in FI.What kind of connection you will use and what is your FI firmware?
