Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Can anyone recommend a good training class to learn Quality of Service protocols and implementation? I have a couple projects coming up that will be relying on QoS on the LAN and WAN and I'd like to learn as much as I can before hand.
I have an issue where one locally connected network is not being advertised by BGP. All the other networks are working fine. Would the "clear ip bgp soft" command work possibly?Non-working network:router1#show ip route 10.xx.x2.0Routing entry for 1...
I am trying to trust the cos value for trunk port fa 0/0/0 on a 2821 router. The trunk port is on a HWIC-4ESW 4 port switch module. I have configured the port to trust cos, but when I run the command "show mls qos interface" the port state shows "u...
I downgraded a 4400 from 4.2 to 4.1 and the configuration was lost. The release notes mention that this "may" happen. Does anyone know if there is a way to prevent it?http://www.cisco.com/en/US/docs/wireless/controller/release/notes/crn411850.html#...
Good point about the data rates. That could have a huge impact as well if your multicast traffic is sent at 1 MBPS.Aruba has a feature that will bump up the data rate for broadcast and multicast to the highest supported rate that all associated clie...
I am just starting to test multicast video myself and I am running into the same issue. Even a well designed wireless LAN with QOS is still going to have collisions. With unicast video, the packets can be resent at the 802.11 layer. With multicast...
Ok, so I can only tag the traffic on the HWIC-4-ESW on a per-port basis? There is no way for the port to trust the COS markings that are already on the traffic passing through the port?Here is what the product page says.http://www.cisco.com/en/US/pr...
I don't think the 4404 will allow more than 48 APs to join without more than one Gig port enabled. Throughput wise you are probably OK, but the controller has a hard limit of 48.I see this behavior on my 4402-50AP models. If I only have one gig por...
