The web interface on the rv134w is dated 2015, and doesn’t support Windows 10 Edge. (The login screen doesn’t render correctly, so you cannot even log in.)
What plans are there for fixing this, please?
It looks as if it should be very straightforward to configure the RV134W to connect to an Azure VN gateway: put in the gateway and subnet addresses, and let it go. However, I don't get a connection. I'm using the Basic SKU. The logging is unillumi...
I downloaded the full zip from http://tools.cisco.com/support/downloads/go/Model.x?mdfid=281795035&mdfLevel=null&treeName=Routers&modelName=Cisco%20Configuration%20Professional&treeMdfId=268437899from the 1st link, but it seems to be corrupt. The 2n...
Many thanks for looking. On closer investigation this appears to be a problem that occurs under Windows 10 Insider Preview (ie, the next release of Edge, etc). The Cisco web interface does indeed work OK with the current release of Win 10 Enterpris...
Hi Rozana, I'm sorry, but I was reporting on the wrong device. The RV134w seems to work correctly, as you say. I meant to report on the SG350-10 switch (with firmware 2.3.5.63). Sorry for wasting your time.
Well, I tried this again and I now have a tunnel! I don't know what, if anything, I did differently, but the SA came up and the tunnel is established to a policy-routing based Azure gateway using just the simple setup. Perhaps the Azure side wasn't...
Thanks. I'm sorry about the lack of specific information, but that's part of the problem: it's quite hard to debug what is going on, even looking at the logging.Documentation request: It would be helpful to have a documented example of a working S2S...
