Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have two catalyst 4506 switches and a dozen catalyst 2950 switches, what is the best way to managing and monitoring these switches? Is the ciscoworks sufficient?
Hi,we need to add a new switching module into a running catalyst 4506 currently has one free slot, and add six (6) WS-G5484 GBIC modules into this switching module.My question is can this be done while the switch is powered on? or it has to be done w...
I am looking at a running-config of a C2950-SX-48-SI switch and noticed the configuration of the up-link port is like this:interface GigabitEthernet0/1 switchport access vlan 102 switchport mode trunk spanning-tree portfastIn these four lines, are li...
Hi Amit,strange thing is that I have configured one of the ports like this:interface GigabitEthernet6/1 switchport access vlan 102 switchport trunk encapsulation dot1q switchport mode trunkand it has been accepted and it seems worked.maybe I overlook...
Hi Amit,If I do not issue these commands and directly configure individual ports like this:interface GigabitEthernet6/1 switchport trunk encapsulation dot1q swithcport mode trunkIs it OK?Thanks,
