About daniell_longhi

daniell_longhi · 10-27-2008

Hello guys,I have a Cisco 2811 router that is sending out DHCP discovery packets.The only dhcp related line in the config is the 'no dhcp service' command, there is no dhcp command under any interface command.Do you know how can I turn off this ?rout...

daniell_longhi · 09-16-2008

Hello guys,Do you know the difference between "by power cycle (SP by power-on)" and just "by power-on"? ... if there is any...*Time since mainsw1 switched to active is 9 hours, 5 minutesSystem returned to ROM by power cycle (SP by power-on)System res...

daniell_longhi · 07-31-2008

hello guys,Do you know if there is a way to retrieve the output of of 'show tech-support' and 'show logging' via snmpget or snmpwalk?Thanks,Daniel

daniell_longhi · 11-03-2008

I got it:debug ip sla traceNov 1 14:03:36.754 EDT: IP SLAs(23679) dhcp operation: Starting dhcp operationNov 1 14:03:37.394 EDT: IP SLAs(23679) dhcp operation: request gave address 10.2.173.14 255.255.248.0 in 639 msNov 1 14:04:36.756 EDT: IP SLAs...

daniell_longhi · 10-28-2008

John,The 'no ip bootp server' was already there.Rick,the 2 subinterfaces are configured with static ip addresses and the interface Fast0/0 has the 'no ip address' command. There is no interface configured to obtain the ip in negotiation mode.A frien...

daniell_longhi · 10-28-2008

Hi John,No, I'm not using ip helper.These are the configs of the interfaces:interface FastEthernet0/0.351 description subnet10.0.168.0/21-vlan351 encapsulation dot1Q 351 native ip address 10.0.168.10 255.255.248.0 ip access-group xyz in no ip redirec...

Member Since	‎01-19-2007 10:25 AM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	7

User Statistics

User Activity

Cisco 2811 - turn off dhcp client

by power-on .VS. by power cycle (SP by power-on)

show tech-support/show logging - could I retrieve via SNMP?

Re: Cisco 2811 - turn off dhcp client

Re: Cisco 2811 - turn off dhcp client

Re: Cisco 2811 - turn off dhcp client