Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi! I just installed a PIX Failover. Failover is working except w/ VPN. VPN client can connect to the active PIX device whether Primary or Secondary is the active one. Problem is when a Failover occurs and a VPN client is connected, the traffic is n...
Hi!I just got the VPN client connecting into the PIX authenticate direct to Active Directory. ( No radius in between)My problem is we want to selectively give VPN access to users in the AD. Right now, everyone in the AD can log-on via VPN client. in ...
Hi! I was looking at the following DST document:http://www.cisco.com/en/US/partner/tech/tk648/tk362/technologies_tech_note09186a00807ca437.shtmlIn particular I was looking for the update on Cisco Call Manager Express (with UNITY express , i.e. NM-CUE...
no i'm not running IAS. I'm using this link to configure the PIX with AD. there's no RADIUS or IAS in between.http://www.cisco.com/en/US/products/ps6120/products_configuration_guide_chapter09186a008063b318.htmlit seemed that the Allow or Deny Access ...
Hi Kanishka,Thanks for the prompt reply. question. Isn't this the same as choosing the Allow access in the Dial-in Tab in AD? I'm using Cisco VPN client 4.x to connect to the PIX. When I click on the Deny access in the Dial-in Tab, I'm still allowed ...
i was configuring this same scenario and got the same message. - "Attribute not found"check your AD attribute and see if you are using the correct attribute value.What we did was to check on the AD with a LDAP browser.Our naming attribute is cn. we ...
Got the upgrade done. Migration of the commands was seamless. i had to remove some commands before upgrade ( e.g. pptp , vpdn, etc). No problem reboooting. Even the VPN Xauth was automatically disabled ( this was said to have been enabled by default)...
