Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We recently bought a Buffalo linkstation nas device which has web capabilities and I need to open port 9000 (both ways) in order for this to work. Its been a while since I did anything cisco related and despite my best efforts its still not working. ...
I currently have an ASA 5510 unit. I have a dmz setup which house some web servers and an inside interface. The web servers contain multiple public ip addresses which I have natted and access is fine.What is the most simple way to enable ping for my ...
I currently have an ASA 5510 unit. I have a dmz setup which house some web servers and an inside interface. The web servers contain multiple public ip addresses which I have natted and access is fine.We currently have 253 usable public ip addresses a...
I have remote access vpn setup and I can get connected with no issues. I assigned the vpn a pool of addresses from the end of my inside interface subnet. When connected I can ping any device on that subnet, I can also connect to my switch on the sam...
Hello all I'm very new to cisco and am looking for some advice on the following setup.Here is our network setup:Internet <----- ASA5510<---> Cisco 300 switch (2) <---->LAN clients | ...
Thanks for replying It turned out to be an issue with the nas device and not my settings on the pix. Your answer however is correct for the question that I asked.......Kudos
Manish,Thanks for your help and I fully understand now. I will have the isp do what you suggested so I can use the equipment I allready have in play.Thanks again,Kevin
Ok Thanks and yes to explain better I have x.x.1.x now as a subnet and will be adding two other subnetsx.x.2.xx.x.3.xOn my Asa I have it listening for any ip from the x.x.1.x range, if I understand you correctly as long as my isp points the new subne...
Thanks for your help I was finally able to get it working after i cleared the Nat translation. Your No Nat for the DMZ network command seemed to do the trick..
Tried that and I still can not access anything on the dmz interface. Here is what my config looks like now.ftp mode passivedns domain-lookup Outsidedns domain-lookup Insidedns domain-lookup DMZdns server-group DefaultDNS name-server 66.***.***.45 nam...
