Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Guys,
I have a question regarding the order of the "ip nat inside" statements on an IOS router. We have a situation where a network 192.168.1.0/24 needs to get to the internet and therefore we have the overload statement out Dialer. Then we have a...
Hi Guys, We are having some issues at our office where when users move from one switch to another, the 802.1X authentication does not want to take place. The PC just gets an APIPA address. Now I have read about features that MAC Move and MAC replace ...
Hi All, I have been tasked with setting up out new Corporate Firewall and have been having non-stop issues trying to get connectivity between the ASA and the switch.I am using ASA version 9, and am using the the new feature where one can place all yo...
Hi All,As the heading suggests, I have been tasked with replacement our Corporate Firewall, which is a Check Point, with an ASA 5512X. This is an extremely daunting task. I know there are conversion tools and I have tried them, so please don't sugges...
Hi Guys,I have encountered a weird fix to a problem that I would like to get some clarity on. Basically, we have a Cisco 1600 AP, connecting directly to a Layer 3 switch. The data VLAN (and therefore the VLAN the AP's are in) are VLAN 4. There is a V...
I have configured the "authentication violation replace" command on all the switches and now I no longer get an authentication issue. It seems the switch put the port into an err-disabled state for some reason. I assume it's because it already has an...
Hi Neno, Thanks for the reply. We are using NPS on a Server 2008 R2 virtual machine. The switches are stacked 2960S-48FPS-L running 15.0(2)SE. I will quickly do the debugs and get back to you.Here is the config: aaa group server radius customer-nps s...
It has been sorted out now. It seems the switch was missing the following command. vlan dot1q tag native I don't think I would of had this issue if I had used a different VLAN other than 1. I would however like a similar command that I can use on the...
I have redone the configuration numerous times, also had a CCIE colleague assist. Further switch configuration:interface Vlan1 ip address 172.28.65.11 255.255.255.0 no ip redirectsVLAN 1 is a working VLAN as it is our Management LAN for other devices...
