About Boda

Boda · 04-23-2021

Hello,I built a network using IPv4, used RIPv2 as routing protocol and it worked well. I then tried to also add IPv6 to the network. I did the IPv6 unicast-routing and added the addresses to all the connections. However, when I try to auto configure ...

Boda · 04-19-2021

Hello guys,I'm still new here so, I apologize in advance if I posted the question incorrectly.I'm trying to create a network that consists of 2 buildings. Each building has 3 floors and each floor has its own local network. Below is the IP table for ...

Boda · 04-23-2021

Dear Giuseppe,That makes sense now. Thank you so much, you have helped me a lot. Your efforts are much appreciated.Regards,Boda

Boda · 04-19-2021

Dear Giuseppe,Thank you so much for your explanation, it helped a lot. The whole network works perfect now. This is my first time hearing about auto summary and I will definitely need to read more about it. Much appreciated,Boda

Boda · 04-19-2021

Yes sure. I have attached the zipped file.

Boda · 04-19-2021

I tired RIPv2 like you guys said and I am successfully pinging some devices in the same building, however, I can't seem to ping devices from the other building. I'm trying to research about OSPF and EIGRP. But in the mean time, do you have any idea w...

Boda · 04-19-2021

I am really sorry I don't think I fully understand what you mean. I used the router GUI to add the networks for RIP and this is exactly what is inside each router:128.0.0.0 (the local areas network)128.1.0.0 (The rest are connections between each rou...

Member Since	‎04-19-2021 07:51 AM
Date Last Visited	‎05-07-2021 01:28 AM
Posts	7

User Statistics

User Activity

Can't Auto config end devices using IPv6

RIP not working

Re: RIP not working

Re: RIP not working

Re: RIP not working

Re: RIP not working

Re: RIP not working